User Manual
14
Required Parts
• Wing (left and right) • Short strut pin (4)
• Wing strut end (4) • Long strut pin (4)
• Retainer clip (8) • Aluminum wing tube
• 1/4-20 nylon wing bolt (2) • 4mm nut (4)
• Mid-span cross brace (2)
• Wing assembly (left and right)
Note: Use threadlock on the screws to
prevent them from vibrating loose in flight.
Required Tools
• Hex wrench: 3/32-inch • Threadlock
• Nut driver: 1/4-inch
Step 1
The wing strut is factory assembled and just needs to be
bolted to the wing strut brackets. Attach the strut assembly
to the wing strut brackets using two 4-40 x 1/2-inch
socket head screws and two 4-40 locknuts.
Note: The wide strut goes toward the leading
edge, the narrow strut toward the trailing
edge. The airfoil on the struts will match
the wing as well when they are installed.
Step 2
Thread the wing strut ends and 4mm nuts on the ends
of the struts.
Step 3
The supports attach to the mid-span studs using two long
strut pins and two retainer clips.
Wing Installation