User Manual
13
Required Parts
• Fuselage assembly
• Front seat
• Rear seat
• Hook and loop
• Pilot
• #2 x 1/2-inch sheet metal screw (4)
Required Tools and Adhesives
• Phillips screwdriver
Step 1
Plug the switch harness into the battery and receiver. Slide
the rear seat into position, guiding the wires from the
switch harness behind the seat.
Step 2
Slide the front seat into position in the fuselage.
Step 3
Use four #2 x 1/2-inch sheet metal screws to secure the
floor into the fuselage. The floor will keep the seats from
sliding in the fuselage.
Step 4
Use hook and loop to secure the pilot in the fuselage.
Interior Detail Installation