User Manual

12
 Step 11
Connect the rudder tiller bracket to the tailwheel steering
arm using the two rudder springs. You will need to bend
the springs to attach them on each end using pliers.
 Step 12
Wrap the receiver in 1/4-inch (6mm) foam. Attach the
receiver to the radio tray using a hook and loop strap.
 Step 13
Slide the radio tray into the fuselage and secure its
position using two #2 x 1/2-inch sheet metal screws.
 Step 14
Plug the throttle, rudder, and elevator servos into
the receiver.
Note: A Y-harness is not included for the
elevator servos. If you are not using a 6-
channel radio with the ability to mix the
elevator servos together, you will need to
purchase a reversing Y-harness (EXRA320).
 Step 15
Plug the two 18-inch aileron(457mm) servo extensions
into the receiver. Slide the radio tray cover into position
so it locks into position under the rear cabin wall. Use
two #2 x 1/2-inch sheet metal screws to secure the radio
tray cover inside the fuselage.
Stabilizer and Radio Installation