User Manual

11
 Step 8
Clip the clevis to the strut support bracket. It will be
necessary to adjust the position of the clevis to ensure
the support rods are not causing any twists between the
fuselage, stabilizer and fin. Tighten the nuts against the
clevises once all adjustments have been made.
Note: Use threadlock on the nuts and clevises
to prevent them from vibrating loose in flight.
 Step 9
Connect the clevises for the elevators to the elevator
control horns.
 Step 10
Connect the clevises for the rudder to the rudder control
horns. Attach the rudder tiller bracket to the rudder
using two #2 x 5/8-inch sheet metal screws. It is highly
suggested to remove the screws, then apply a few drops of
thin CA into the holes and reinstall the screws.
Stabilizer and Radio Installation