User Manual

10
 Step 4
Attach the tail wheel assembly to the fuselage using two
#6 x 5/8-inch sheet metal screws. The forward screw
goes through the gear and into the fuselage, while the rear
screw goes through the two large strut support brackets,
then through the gear and into the fuselage.
 Step 5
Attach the two small strut support brackets to the fin
using a 4-40 x 5/8-inch socket head screw and a 4-40
locknut. There will be a bracket on the right and left of
the fin when complete.
 Step 6
Remove the clevis from each of the support rods. Use a
hobby knife to clean the paint from the threads. Thread a
2-56 nut onto the threads, then replace the clevis.
 Step 7
Use a 4-40 x 5/8-inch socket head screw and 4-40
locknut to attach the support rods to the stabilizer. The
longer 10-inch (254mm) rod attaches to the top of the
stabilizer, while the shorter 9
1
/
2
-inch (241mm) rod
attaches to the bottom of the stabilizer.
Stabilizer and Radio Installation