User Manual
8
Step 6
Insert the Z-bend from the 27
1
/
2
-inch (700mm)
rudder pushrod into the rudder tiller arm from the
bottom as shown.
Step 7
Slide the rubber boot onto the pushrod wire. The boot will
be pressed against the rudder tiller arm.
Step 8
Use two 4-40 x 1/2-inch socket head bolts to attach
the rudder to the float. Use a small amount of silicone
adhesive to secure the rubber boot to the float.
Note: Use care not to get silicone
adhesive on the pushrod wire.
Note: Make sure to use threadlock on the
screws to prevent them from vibrating loose.
Step 9
Remove the servo arm from the servo. Use the hardware
provided with the servo to mount it inside the float. The
output of the servo will face toward the front of the float.