User Manual

 Step 4

With the fuselage inverted, use two 8-32 x 3/4-inch socket

head bolts, four nylon washers and two 8-32 locknuts to

attach the front bracing to the float mounting brackets on

the fuselage. The bracing and washers are installed in the

same fashion at the fuselage as they are at the float. Slide

the tubing so it is at the inersection of the two wires to

prevent them from rubbing and causing radio interference.

Apply medium CA to secure the position of the fuel

tubing.

Nylon locknut

Diagonal brace

Nylon washer

Cross brace wire

8-32 x 3/4-inch socket head

bolt w/shoulder

Front Strut to

Fuselage Attachment

Front

 Step 5

Use two 8-32 x 3/4-inch socket head bolts, four nylon

washers and two 8-32 locknuts to attach the rear bracing

to the float mounting brackets on the fuselage. The

bracing and washers are installed in the same fashion at

the fuselage as they are at the float. Slide the tubing so it

is at the inersection of the two wires to prevent them from

rubbing and causing radio interference. Use medium CA

to glue the tubing in position.