User Manual

 Step 23

Remove the strut end fitting from one end of the

preassembled 11-inch (280mm) wire braces. Slide a

1/4-inch (6mm) piece of fuel tubing onto the wire. The

fuel tubing will be secured later in the manual.

 Step 24

Adjust the strut end fittings so the distance between

the center of the screw heads will measure 11

-inch

(302mm) as shown. Use threadlock on the nuts and ends

to prevent them from vibrating loose. The 4-40 nut is then

tightened against the ends to keep them from rotating and

vibrating loose as well. Prepare both braces at this time.

11 / -inch

(302mm)

Note: Make sure to use threadlock on the

screws to prevent them from vibrating loose.

 Step 25

Use a 8-32 x 3/4-inch socket head bolt w/shoulder, 8-32

locknut and two #8 nylon washers to attach the 8

-inch

(216mm) rear diagonal strut to the strut bracket. Note that

the front strut has a hole in one end which the diagonal

brace will fit into when installed. Install both rear diagonal

braces at this time.

Nylon locknut

Diagonal brace

Nylon washer

Cross brace wire

8-32 x 3/4-inch socket head

bolt w/shoulder

Rear Strut to

Float Attachment

Front