User Manual

12
 Step 21
Adjust the strut end fittings so the distance between
the center of the screw heads will measure 11
3
/
16
-inch
(284mm) as shown. Use threadlock on the nuts and ends
to prevent them from vibrating loose. The 4-40 nut is then
tightened against the ends to keep them from rotating and
vibrating loose as well. Prepare both braces at this time.
11 / -inch
(284mm)
3
16
 Step 22
Use a 8-32 x 3/4-inch socket head bolt w/shoulder, 8-32
locknut and two #8 nylon washers to attach the 7
1
/
2
-inch
(190mm) front diagonal strut to the strut bracket. Note that
the front strut has a hole in one end which the diagonal
brace will fit into when installed. Install both front
diagonal braces at this time.
Nylon locknut
Diagonal brace
Nylon washer
Nylon washer
Cross brace wire
8-32 x 3/4-inch socket head
bolt w/shoulder
Front Strut to
Float Attachment
Front