User Manual

11
 Step 17
Remove the strut end fitting from one end of the
preassembled 19
1
/
4
-inch (489mm) wire braces. Slide a
1/4-inch (6mm) piece of fuel tubing onto the wire. The
fuel tubing will be secured later in the manual.
 Step 18
Adjust the strut end fittings so the distance between
the center of the screw heads will measure 20
1
/
4
-inch
(514mm) as shown. Use threadlock on the nuts and
ends to prevent them from vibrating loose. The 4-40 nut
is then tightened against the ends to keep them from
rotating and vibrating loose as well. Prepare both wire
braces at this time.
20 / -inch
(514mm)
1
4
 Step 19
Use four 4-40 x 1/2-inch socket head screws to attach
the wire braces between the cross braces. Once the wire
braces are installed, go back and tighten the eight 8-32
x 1
1
/
4
-inch socket head machine bolts w/shoulder. Slide
the tubing so it is at the intersection of the two wires to
prevent them from rubbing and causing radio interference.
Use medium CA to secure the fuel tubing in position.
Note: Make sure to use threadlock on the
screws to prevent them from vibrating loose.
 Step 20
Remove the strut end fitting from one end of the
preassembled 10
1
/
4
-inch (260mm) wire braces. Slide a
1/4-inch (6mm) piece of fuel tubing onto the wire. The
fuel tubing will be secured later in the manual.