User Manual

10
 Step 14
Slide the cross brace into the opening on the side of the
float. Check that the holes in the float align with the brace,
as there is a front and rear brace and the holes do not
match. Use two 8-32 x 1
1
/
4
-inch socket head machine
bolts w/shoulder to attach the strut bracket. The screws go
through the bracket, cross brace and into the preinstalled
blind nuts inside the float.
Rear Cross Brace Hole Alignment
Front Cross Brace Hole Alignment
Front
Of
Float
Note: Leave the screws slightly loose until
the bracing has been fully installed.
Note: Make sure to use threadlock on the
screws to prevent them from vibrating loose.
 Step 15
Install the rear cross brace following the same procedure
as the previous step.
 Step 16
Repeat the two previous steps to attach the remaining float
to the cross braces.