Installation & Assembly

2
Panel
siding
up
1-1/2"
Finish nails
1-1/2"
AC
A
C
AC
Panel siding
down
3/4"
1" Screws
BB
BB
D
C
TEMPLATE
Panel siding
down
BB
BB
D
A
B
C
A. Position Side Panel 11-3/4” x 19-1/8” (A)
on top of two Interior Corner Supports 1-1/2” x
2-1/2” x 10” (AC) with supports flush to sides
and top of Panel and Panel siding facing up.
Secure with six 1-1/2” finish nails (C) through
Panel into supports.
Repeat other Side Panel 11-3/4” x 19-1/8” (A)
and two Interior Corner Supports 1-1/2” x
2-1/2” x 10” (AC).
B. Position Side Panel 11-3/4” x 20” (D) on
top of Corner Trim 3/4” x 1-1/2” x 10-1/2”
(BB) with Corner Trim flush to sides and
bottom of Panel. Secure with two 1” screws
(C) through Panel into Corner Trim.
Repeat other Side Panel 11-3/4” x 20” (D)
and two Corner Trim 3/4” x 1-1/2” x 10-1/2”
(BB).
D
C. Locate the cardboard cutting Template shown in
Step C, you will need it for the next step. Find your
building on the template and cut the template to the
building pitch. Check the angle of the template by
placing it on the roof.
D. Using the Template, cut out the profile that matches
your building. See Template for building chart.
IMPORTANT: Make sure you only cut the 11-3/4” x 20”
Panels (D) with the Corner Trim (BB) pieces attached.
CUPOLA CUTTING TEMPLATE
8‘ w & 10’ w Saltbox
8‘ w Gambrel
MARCO SERIES
10‘ w Gambrel
10‘ w Gable
8‘ w Gable
8‘ w, 10’ w & 12’ w Gable
8‘ w, 10’ w & 12’ w Gambrel
PREMIER SERIES
SIGNATURE SERIES
VALUE LINE SERIES
HERITAGE SERIES
LDR 10/25/04 CH
#16197