User's Manual
Table Of Contents
- 1-1 Package Contents
- 1-2 Features
- 1-3 Precautions
- 1-4 Outlook
- 1-5 Technical Specifications
- 2 Installation
- 2-1 Installation Requirements
- 2-2 Getting Start
- 3 Configuring the GuestWiFi
- 3-1 Setting Wizard
- 3-2 Advanced Setup
- 3-3 System Status
- 3-4 System Tools
- Appendix A Signal Connection Arrangements
- Appendix B Regulations/EMI Compliance
- LIMITED WARRANTY
Appendix A Signal Connection Arrangements
RJ-45 Ethernet Port
The GuestWiFi RJ-45 Ethernet port can connect to any networking devices that use a standard LAN
interface, such as a Hub/Switch Hub or Router. Use unshielded twisted-pair (UTP) or shield
twisted-pair (STP) cable to connect the networking device to the RJ-45 Ethernet port.
Depending on the type of connection, 10Mbps or 100Mbps, use the following Ethernet cable, as
prescribed.
10Mbps: Use EIA/TIA-568-100-Category 3, 4 or 5 cable.
100Mbps: Use EIA/TIA-568-100-Category 5 cable.
Figure 86 RJ-45 Connector and Cable Pins
Note: To prevent loss of signal, make sure that the length of any twisted-pair connection does not
exceed 100 meters.
Easy Hotspot Kit
87