User's Manual
Table Of Contents
- 1-1 Package Contents
- 1-2 Features
- 1-3 Precautions
- 1-4 Outlook
- 1-5 Technical Specifications
- 2 Installation
- 2-1 Installation Requirements
- 2-2 Getting Start
- 3 Configuring the GuestWiFi
- 3-1 Setting Wizard
- 3-2 Advanced Setup
- 3-3 System Status
- 3-4 System Tools
- Appendix A Signal Connection Arrangements
- Appendix B Regulations/EMI Compliance
- LIMITED WARRANTY
1-4-2 Rear Panel
The rear panel of the GuestWiFi is shown below.
Figure 3 GuestWiFi Rear Panel
1. LAN (1-4):
The rear panel supports four auto-sensing RJ-45 ports and all ports can be auto-switched to MDI-II
connections. The LAN ports used for linking hosts or other network devices. The individual port can be
either connected to 100BaseTX networks or 10BaseT networks. When connecting to a 100BaseTX
network, the ports operate at 100Mbps in half-duplex mode or 200Mbps in full-duplex mode. When
connecting to a 10BaseT network, the ports operate at 10Mbps in half-duplex mode or 20Mbps in
full-duplex mode.
2. WAN: One Ethernet port used for linking xDSL or Cable Modem.
3. Reset Button:
The GuestWiFi has a reset button at the rear panel of the device. Use this function to reset the system
back to factory defaults.
4. Power Jack: Used to connect the external power supply with the GuestWiFi.
1-5 Technical Specifications
1-5-1 Hardware Specifications
Network Specification
IEEE802.3u 10BaseTx Ethernet
IEEE802.3u 100BaseTX Fast Ethernet
IEEE802.11b/g/n Wireless LAN
ANSI/IEEE 802.3 NWay auto-negotiation
Wi-Fi Compatible
Connectors
Easy Hotspot Kit
7