User's Manual
Table Of Contents
- 1-1 Package Contents
- 1-2 Features
- 1-3 Precautions
- 1-4 Outlook
- 1-5 Technical Specifications
- 2 Installation
- 2-1 Installation Requirements
- 2-2 Getting Start
- 3 Configuring the GuestWiFi
- 3-1 Setting Wizard
- 3-2 Advanced Setup
- 3-3 System Status
- 3-4 System Tools
- Appendix A Signal Connection Arrangements
- Appendix B Regulations/EMI Compliance
- LIMITED WARRANTY
1-4-1 Top Panel
The top panel of the GuestWiFi is shown below.
Figure 2 GuestWiFi Top Panel
LEDs Indication
LED State Description
PWR Off The GuestWiFi is not receiving electrical power.
Green The GuestWiFi is receiving electrical power.
SYS Off The GuestWiFi status is defective.
Green The GuestWiFi status is complete.
Green (Blinking) During firmware upgrades, this system LED will blink.
WAN Off Port has not established any network connection.
Green A port has established a valid 10/100Mbps network connection.
Green (Blinking) 10/100Mbps traffic is traversing the port.
LAN-1~
LAN-4
Off Port has not established any network connection.
Green A port has established a valid 10/100Mbps network connection.
Green (Blinking) 10/100Mbps traffic is traversing the port.
WLAN Off The Wireless is not ready.
Green The GuestWiFi has established a valid wireless connection.
Green (Blinking) The Wireless connection is active.
Easy Hotspot Kit
6