User's Manual

Handlink AP-100
Commercially Confidential
69
7.3. SNMP Setting
Figure 7-3 SNMP Configuration
Enable SNMP: Enable or disable SNMP.
Read Community：SNMP protocol read community; by default it is “public”
Write Community：SNMP protocol write community, by default it is “write”
Show：Show write community phrase
Trap Host ID： SNMP Trap host ID, it supports Max. 4 Trap Host
Trap Host： Trap Host IP address
Trap Port： Trap port, by default it is 162
Trap Community：Trap community information
Enable：Trap Host state (enabled or disabled)
Press ：To edit Trap Host