User's Manual

Handlink AP-100

Commercially Confidential

Minimum signal for association: Set the minimum signal value (SNR) for client can associate to

this WLAN. The range is 0~100dB, and 0 means disable.

Disconnect Signal Threshold：Set the signal threshold value (SNR) for client to disconnect to this

WLAN.

Disconnect Packet Threshold：Set the packet threshold value (SNR) for client to disconnect to this

WLAN.

Back to WLAN List：Go back to previous page

Procedures：

1. Select Configuration -> Wireless -> Radio0 (2.4G) -> WLAN to click “More…” behind

the WLAN, and then select WLAN General.

2. Enable WLAN select to enable this WLAN

3. VLAN Pass Through allow or don’t allow VLAN pass through

4. VLAN TagId Set VLAN ID

5. SSID set SSID

6. Allow Intra-WLAN User Isolation: Allow or block intra-WLAN User communication.

7. Max Clients Maximum is 64

8. Click Submit

9. Click Save&Apply to apply

2. WLAN X (0-7) Security

AP-100 2.4GHz supports Open, Shared Key, WPA, WPA-PSK, WPA2, WPA2-PSK, WAPI,

WAPI-PSK authentication mode, and Disabled, WEP, AES, TKIP, SMS4 cipher mode.

Select Configuration -> Wireless -> Radio0 (2.4G)-> WLAN to edit “More…” WLAN, and then

select WLAN Security to access to security configuration page.