User's Manual

Handlink AP-100

Commercially Confidential

Figure 6-13 WAN/LAN Interface Assignment

Ethernet/Radio (2.4G): LAN interface or WAN interface, only work in gateway mode.

Enable NAT Mode: If NAT Mode is set to "Disabled" then the AP will not perform any network

address translations and all IP traffic will be passed from the wireless clients to the DS (Ethernet)

port or wireless bridge (802.11a radio) without any modification. If NAT Mode is set to "Enabled"

then the AP will perform network address translations on all traffic being passed from the wireless

clients to the DS ( Ethernet) port or wireless bridge (802.11a radio). The NAT will translate IP

traffic address's between the wireless client subnet and the DS subnet

6.2.1.1.4. LAN Setting (IPv4)

LAN IP Address: IP address of local area network.

LAN IP Address Mask: IP address mask of local area network

6.2.1.1.5. Ethernet Mode

In switch mode and Gateway mode, there are 2 types: Auto and Manual

1） Auto