User's Manual

Handlink AP-100
Commercially Confidential
2
7
6 The whole committing changes progress, it is no need to reboot AP-100.
6.2. Basic Configuration
6.2.1. Basic System Configuration
System configuration web includes two parts: System Info setting and NTP Setting.
NTP is a network time protocol for the AP-100 to synchronize the system time. NTP is Enable by
default. If NTP is needed, IP address of the NTP server must be added and AP-100 will synchronize
with the NTP server. It is useful to maintain the network and make sure all APs are using the same
system time by setting the same NTP server.
Please select Configuration -> System to configure System Info Setting and NTP setting.
Figure 6-6 NTP Setting
System Name：Set system name of the device, the system name can be up to 255 characters long.
System NE ID：Set system NE ID, the system NE ID can be up to 64 characters long.
System Location：Set system location, the system location can be up to 255 characters long.
Enable NTP： Enable or disable NTP function, by default it is selected.
IP Address Type：IPv4 or IPv6. (Please note that IPv6 is available to be select after enable IPv6 in
Network setting web page, refer to section 6.3).
NTP Server IP： NTP server IP address, please click “
” to add new NTP server IP address.
NTP Polling Interval： By default, it is 600s
NTP Time Zone： Time Zone setting, by default it is Asia/Hong Kong.