User's Manual

Handlink AP-100
Commercially Confidential
10
6. Type in an “IP address”, for example, 192.168.1.2, which is under the same subnet as the
Default IP Address of AP-100 AP/CPE (10.59.100.1).
7. Using the default “Subnet mask” (default: 255.255.255.0) setting in the first time.
8. Keep the “Default gateway” as “Blank”.
9. Keep the “Preferred DNS server” and “Alternate DNS server” as “Blank” also.
10. Click “OK” when you finish setting and close the Window.
Figure 4-4 Internet Protocol (TCP/IP) Properties in Windows XP
4.2. Check Access
“ping” utility of Command Prompt is a handy tool to check the access to the AP-100 AP/CPE.
1. Go to the Command Prompt by typing “cmd” in “Run”.
2. Type command:
ping 10.59.100.1
The AP-100 AP/CPE shall respond to your ping request if AP-100 AP/CPE and your PC
have a correct connection.
NOTE: Using the same PC to ping different AP-100 AP/CPE may cause ping failure. This is
because AP-100 AP/CPE has the same default IP address but different MAC addresses. You need
to type command “arp –d” in Command Prompt to clear ARP table on PC before each ping.
4.3. Configuration with Web-Admin
The AP-100 can be accessed through a Web Browser, for example, Internet Explorer (IE).