Instruction Manual

23
Using ActiveSync - 2
NAUTIZ X5 Manual
2
2 When the terminal is successfully connected to the computer, the
[Microsoft ActiveSync] program will start automatically. Click on
the [Search] button.
3 The <Mobile Devices> folder shows the image, music or
document folders on the terminal. You can save the fi les on
the computer.
Precautions when Using ActiveSync
The message “Unknown Device” pops up after the
computer detects the USB device
This message may be displayed when you switch on the
terminal while mounted on the desktop charger. If you
remove the terminal and then put it back on the charger, the
ActiveSync program will work properly.
The message “Connecting…” continues
Remove the terminal from the desktop charger to disconnect
it from the computer.
In [ActiveSync], select File
> Set Connection > <Allow USB
Connection>, and then, click on [ok]. Connect the terminal
again.
If connection attempts continue to fail and the message
“Unknown Hardware Device” pops up
Abnormal status of the USB host on the computer may result
in connection failure. Remove the terminal from the desktop
charger, reboot the computer, and then, put the terminal on
the desktop charger again.
The terminal does not work when you
remove and put back the battery
To prevent this problem, you should press the [Power]
button or select [Exit] on the Start menu with the stylus
pen to allow Windows Mobile (or Windows CE) to “Exit
System” before you remove the battery.
If you had to remove the battery due to an unavoidable
situation, and the terminal does not work properly,
press both the button and the button at
the same time to make a hard reset.
Note that a hard reset deletes data from the memory.
Only the data in the fi le storage are preserved.