User's Manual

Algiz 10X Manual
31 handheld
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1. This device must not cause harmful interference, and
2. This device must be able to withstand any interference received, including interference that may
cause undesired operation.
FCC Warning
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorienting or relocating the receiving antenna.
Increasing the distance between the equipment and the receiver.
• Connecting the equipment to a different outlet from that to which the receiver is connected.
• Consulting the dealer or an experienced radio/TV technician for help.
Caution:
To comply with the limits for an FCC Class B computing device, always use the shielded signal cord
supplied with this unit. The Federal Communications Commission warns that changes or
modifications to the unit not expressly approved by the party responsible for compliance could
invalidate the user’s authority to operate the equipment.
FCC RF Radiation Exposure
This equipment complies with the FCC RF radiation exposure limits stipulated for an uncontrolled
environment. This device and its antenna must not be co-located or operated in conjunction with any
other antennas or transmitters. To comply with FCC RF exposure compliance requirements, the