User Guide

Moving the cursor
Software applications will normally allow you to
move the cursor a character or line at a time, using
the arrow keys: I, J, G and H. To move the
cursor up or down several lines, use Q and R.
Resetting the MP2500
Caution: Resetting the MP2500 may lose your
most recent data entries. You should not need to
reset the MP2500 in normal operation - use this
procedure in emergency only. Report the
problem to your system provider.
If the MP2500 locks up or fails to operate, you MAY
need to reset it as follows:
Refer to the previous section SETTING UP. Carry
out step 3, Reset the MP2500 and step 4, Starting
MS-DOS.
If this fails, try another set of Alkaline batteries or
(charged) battery pack (see Replacing the Battery).
If this does not help, contact your system provider
for assistance.
LOADING SOFTWARE
Your system provider may have already loaded the
application software before issuing the MP2500 to
you.
Software is normally loaded onto an MP2500 by
downloading files from a PC. To do this you need:
1. A suitable cable to connect between the PC and
the MP2500. HUSKY approved cables are
available via your system provider.
2. A file transfer program. The HUSKY file transfer
utility, HCOM, is provided for the MP2500.
For further details, please consult your system
provider or the MP2500 System Developer's Guide
(or instructions provided with the application
software).