User Guide

CLEANING
If the screen gets dirty or smeared, clean it with a
clean cloth. If the MP2500 gets very dirty, it should
be cleaned:
• Make sure that the battery cap is tight. If you
have dropped the MP2500, check that the case
and seals are intact.
• Gently rinse the unit under clean running water
(no more than hand hot, 40°C). Do not immerse
the unit unnecessarily, or use a high pressure jet.
• To remove stubborn deposits, use a soft bristle
brush and a mild detergent. TREAT THE
KEYBOARD GENTLY.
• Blow any water out of the connectors, then leave
it to drain and air dry. DO NOT EXPOSE THE
UNIT TO TEMPERATURES ABOVE 55°C.
• Polish the screen with a clean cloth.
CAUTION: Do not use organic solvents or harsh
detergents, as they may damage the casing.
PERIPHERALS
CAUTION: Connect only approved cables and
peripherals to your MP2500.
To connect a suitable peripheral to the MP2500:
• Turn off the MP2500 (and peripheral, if
appropriate).
• Fit the peripheral to the connector.
• Use connector locking mechanisms where fitted.
• Turn on the MP2500 (and peripheral, if
appropriate).
To disconnect a peripheral:
• Turn off the MP2500 (and peripheral, if
appropriate).
• Disconnect the peripheral from the connector.