User Guide

CLEANING
If the screen gets dirty or smeared, clean it with a
clean cloth. If the FS3 gets very dirty, it should be
cleaned:
• Make sure that the battery cap is tight. If you
have dropped the FS3, check that the case and
seals are intact.
• Gently rinse the unit under clean running water
(no more than hand hot, 40°C). Do not immerse
the unit unnecessarily, or use a high pressure jet.
• To remove stubborn deposits, use a soft bristle
brush and a mild detergent. TREAT THE
KEYBOARD GENTLY.
• Blow any water out of the connectors, then leave
it to drain and air dry. DO NOT EXPOSE THE
UNIT TO TEMPERATURES ABOVE 55°C.
• Polish the screen with a clean cloth.
CAUTION: Do not use organic solvents or harsh
detergents, as they may damage the casing.
PERIPHERALS
CAUTION: Connect only approved cables and
peripherals to your FS3.
To connect a suitable peripheral to the FS3:
• Turn off the FS3 (and peripheral, if appropriate).
• If fitted, remove the protective cap from the
appropriate connector.
• Fit the peripheral to the connector.
• Use connector locking mechanisms where fitted.
• Turn on the FS3 (and peripheral, if appropriate).
To use the Infrared (IR) communications option (if
fitted), the FS3 IR port must be pointing at the
peripheral's IR port and be no more than 1m away. If
you have difficulties, try again at a closer range.
To disconnect a peripheral:
• Turn off the FS3 (and peripheral, if appropriate).
• Disconnect the peripheral from the connector.
• If provided with a protective cap, fit it to the
connector.