User Guide

CLEANING
If the screen gets dirty or smeared, clean it with a
clean cloth. If the FS/2 gets very dirty, it should be
cleaned:
● Make sure that the battery cap is tight. If you
have dropped it, check that the case and seals
are intact.
● Gently rinse the unit under clean running water
(no more than hand hot, 40˚C). Do not immerse
the unit unnecessarily, or use a high pressure jet.
● To remove stubborn deposits, use a soft bristle
brush and a mild detergent. TREAT THE
KEYBOARD GENTLY.
● Blow any water out of the connectors, then leave
it to drain and air dry. DO NOT EXPOSE THE
UNIT TO TEMPERATURES ABOVE 55˚C.
● Polish the screen with a clean cloth.
CAUTION: Do not use organic solvents or harsh
detergents, as they may damage the casing.
PERIPHERALS
CAUTION: Connect only approved cables and
peripherals to your FS/2.
To connect a suitable peripheral to the FS/2:
● Turn off the FS/2 (and peripheral, if appropriate).
● If fitted, remove the protective cap from the
appropriate connector.
● Fit the peripheral to the connector.
● Use connector locking mechanisms where fitted.
● Turn on the FS/2 (and peripheral, if appropriate).
To disconnect a peripheral:
● Turn off the FS/2 (and peripheral, if appropriate).
● Disconnect the peripheral from the connector.
● If provided with a protective cap, fit it to the
connector.