TM Please read these instructions before using your FS/2 HUSKY FS/2 USER LEAFLET
USING YOUR FS/2 The FS/2 hand-held computer is rugged and waterproof, but to help ensure trouble-free operation, we recommend that you: Check how to use your application before beginning work. Carry a spare set of batteries ● ● Avoid subjecting your FS/2 to: ● unnecessary temperature extremes - bright sunlight in a vehicle, for example ● ● ● prolonged immersion in water physical mistreatment The FS/2 leaves the factory fitted with non-rechargeable Alkaline batteries and is ready for use.
Note: Keyboard and connector layouts vary on certain models. 1 2 PORT 1 CONNECTOR: main serial port. PORT 2 CONNECTOR: second serial port. 1a Alternatively, on some models a single connector is provided, combining PORT 1 and PORT 2. 3 4 5 6 7 8 CONTACTS: on the rear of the unit, these connect to the FS/2 Communications and Charging Rack, if this option is fitted. FUNCTION KEYS: press to use application functions. POWER KEY: press to turn on or off.
CONTROLS Note: Your application’s user instructions may supplement the following information. Turning on and off Press P to turn on, or off. To conserve power, the FS/2 turns off automatically if you have not pressed any keys for a short while. Screen contrast Adjust the screen contrast for optimum readability, especially at temperature extremes. Hold down either S (SHIFT) key and press U (UP ARROW) to increase contrast or D (DOWN ARROW) to decrease contrast.
BATTERIES The FS/2 can be fitted with either rechargeable or replaceable batteries. The FS/2 batteries are designed to last more than a working shift. However, if power does run low, a warning BATTERY LEVEL LOW will be displayed. (After a further period of use, your FS/2 will turn itself off and will not turn on again.) You should do one of the following: Return the FS/2 to your base or office.
Replacing batteries ● Turn your FS/2 off. ● Remove the battery cap by using a suitable coin. Do not allow rain or moisture into the battery compartment. Tilt the unit to slide out the batteries. ● ● ● Slide the fresh batteries into the battery compartment, positive end first. If you are fitting AA size batteries, it is advisable to fit the packing sleeve supplied with the FS/2. ● Refit the battery cap.
CLEANING If the screen gets dirty or smeared, clean it with a clean cloth. If the FS/2 gets very dirty, it should be cleaned: ● ● ● ● Make sure that the battery cap is tight. If you have dropped it, check that the case and seals are intact. Gently rinse the unit under clean running water (no more than hand hot, 40˚C). Do not immerse the unit unnecessarily, or use a high pressure jet. To remove stubborn deposits, use a soft bristle brush and a mild detergent. TREAT THE KEYBOARD GENTLY.
PROBLEMS If you have problems with the FS/2, TELL YOUR SYSTEM PROVIDER, but here are a few quick checks: ● ● ● ● ● If the unit will not turn on, check the batteries’ orientation and try a fresh set of batteries. If you cannot read the display, try adjusting the screen contrast: hold down either S (SHIFT) key and press U or D. If you drop the unit and it stops working, try turning off and on, and check the batteries. Your application may provide a RESET facility.
