User's Manual
Algiz 10XB Manual
40 handheld
FCCWarning
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interferencetoradioortelevisionreception,whichcanbe
determinedbyturningtheequipmentoff
andon,theuserisencouragedtotrytocorrecttheinterferencebyoneofthefollowingmeasures:
‐ Reorientorrelocatethereceivingantenna.
‐Increasetheseparationbetweentheequipmentandreceiver.
‐Connectthe equipment into an outlet on a circuit differentfrom
that to which the receiver is
connected.
‐Consultthedealeroranexperiencedradio/TVtechnicianforhelp.
Anychangesormodificationsnotexpresslyapprovedbythepartyresponsibleforcompliancecould
voidtheuser'sauthoritytooperat ethisequipment.
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two
conditions:(1)Thisdevicemaynotcauseharmfulinterference,and(2)Thisdevicemustacceptany
interferencereceived,includinginterferencethatmaycauseundesiredoper ation
Exposuretoradiofrequency(RF)signals
Body‐wornOperation
This device was tested for typical body‐worn operations. A
minimum separation distance must be
maintained betweenthe user’s body and the handset,including the antenna: 1 cm to comply with
theRFexposurerequirements.