User's Manual

NAUTIZ X4 Manual
53 handheld
10.4. ActiveSync Communication
To synchronize, ActiveSync 4.1 or higher must be installed and configured for the appropriate communication type on the
host workstation and the Handy Terminal. Handy Terminals ship with
ActiveSync already installed. Therefore, if ActiveSync is already installed on the host workstation, you just need to connect
the Handy Terminal to the host workstation (via Handy Terminal peripheral) to initiate communication.
☞NOTE: You can download the most current version of ActiveSync (for Windows XP) or Windows Mobile Device Center (Windows Vista, 7) from
www.microsoft.com.
WARNING: When communicating via ActiveSync, your terminal is designed to be connected to the host workstation with a Handheld
communication peripheral. We recommend use of Handheld peripherals, power cables, and power adapters. Use of any non-Handheld
peripherals, cables, or power adapters may cause damage not covered by the warranty.
10.5. Communication Type
The HANDY TERMINAL supports the following type of communication via ActiveSync through its I/O connector on the
bottom panel:
USB The USB cable and hardware peripherals allow the Handy Terminal to communicate with a workstation through a USB port
or to a network through a USB hub. The Handy Terminal supports high-speed USB communication (USB 2.0); maximum data
transfer rate is 480 Mbps. The Handy Terminal defaults to USB communication out of the box.
10.6. Hardware Requirements for Setup
• AC Adaptor (if needed)
• USB ActiveSync Cable (for USB communication)
• ActiveSync v4.1 or higher (for Windows XP), Windows Mobile Device Center (for Vista and Windows 7) installed on the
host workstation
• Windows XP, Windows Vista, Windows 7 computer.