User's Manual

NAUTIZ X4 Manual
50 handheld
9.5.1. Scanner Settings Applet
Tab
Section
Option
Description
Basic
Scanning
Trigger timeout (sec)
Specifies the trigger time out in
seconds. If a barcode is not
decoded within the specified
timeout, the default Notifier
indicates that decoding is failed
Enable Auto Scan
Enable Auto Scan with specified
interval.
Auto Scan interval (sec)
Set Auto Scan interval time.
Continuous Scan
Enable Continuous Scan without any
interval.
Enable Center Window
(IT5300SR device only)
Enable Center window. Bar
codes are decoded only if they are
within the specified windows
Decode Mode(IT5300SR
device only)
Standard:
Quick Omni (By default) :
Delay Before
Decoding(IT5300SR device
only)
Start to decoding after specified
milliseconds
Values: 0(default), 100, 200, 300,
400, 500, 600, 700, 800,
900, 1000
Wedge mode
User Message
Select Result Type
User Message
Keyboard Event
Clipboard(default)
Terminator
Select the desired barcode end method
from the pull down list.
Values: None, CRLF, Space,
Tab
Power Save Options
(N4313 device only)
Power Save Mode
Select Power Save Mode
OFF
SLEEP
HIBERNATE(default)
Power Save TimeOut
(sec)
1~65535
Notification
Beep
If enabled
– plays audio sound
Volume
Set sounds volume.
Good read
Set sound to indicate good read.
Bad read
Set sound to indicate bad read.
LED
Enable
Enable visual scan indicators.
Vibrator
Good read
Set vibration time after
good read.