Manualshelf

User's Manual

ManualsBrandsHandheld Group ManualsComputers & AccessoriesMobile Computer
31323334353637383940
NAUTIZ X4 Manual
30 handheld
Soft Reset (Warm Boot)
A soft reset re-boots the terminal without losing RAM data, terminates all running applications, reloads the OS, and
launches Autoinstall, which re-initializes any CAB or REG files in \AutoInstall\Cabfile folder.
You would perform a soft reset 1) when the terminal fails to respond, 2) after installing software applications that require a
reboot, or 3) after making changes to certain system settings, or 4) to install new CAB or REG files.
To perform a Soft Reset:
1. Press the Power button for 3 seconds and choose the Soft Reset on the power menu .
2. When the reset is complete, the Desktop appears.
Hard Reset (Cold Boot)
CAUTION:
A hard reset erases all of the data and applications stored in RAM memory, reloads the OS, and
launches Autoinstall, which installs any CAB or REG files in the \AutoInstall\Cabfile.
Hard resets automatically launch a soft reset as part of the boot process if there are CAB files present.
To Perform a Hard Reset:
1. Press the Power button for 3 seconds and choose the Hard Reset on the power menu.
2. When the reset is complete, the Desktop appears.
To perform a Hard Reset if the terminal has stopped responding, press and hold the Power button for 8 seconds until the
terminal starts to re-boot.
Factory Reset
CAUTION:
To prevent data loss, back up all user data to an SD card or external memory device before performing
an upgrade or factory reset.
To Perform a Factory Reset:
1. Perform a Hard Reset
2. The terminal will reboot automatically and you will see first booting screen
3. Press “1277” when version information is displayed and then you will enter bootloader menu.
4. Press “12” to perform a factory reset.
5. When the clean boot is completed, do a touch calibration.
4.21. Suspend Mode
Suspend Mode suspends terminal operation. The terminal appears to be “off” when in Suspend Mode. The terminal is
programmed to go into Suspend Mode automatically when inactive for a specified period of time. You can set this time
period in the Power setting.
To suspend and resume operation, press the Power button. You may also press the front Scan key to wake a suspended
device unless the battery door has been removed and replaced.