User's Manual

NAUTIZ X4 Manual
24 handheld
Speaker
The integrated speaker sounds audio signals as you scan bar code labels and enter data, but emits no ambient
noise on system activity (i.e., processor, memory access, radio traffic, etc.). The speaker can also be used for
playing sounds (e.g., WAV or MP3 files).
The speaker meets the following SPL levels at 10cm:
• 500Hz–80dB
• 1kHz–90dB
• 4kHz–90dB
Stylus and tether
HANDY TERMINAL is shipped with a stylus inserted in a loop on the tether. Store the stylus in the Lanyard when
you’re not using it; see Using the Stylus on paragraph 3.8.
4.9. Left Side Panel Layout
Side Button
You can set the volume using the Volume Button and scan using the Scan button.
4.10. Installing Memory Cards
The HANDY TERMINAL supports Micro Secure Digital (SD) memory cards up to 32GB. Sandisk, Kingstone and ATP micro
SD recommended
To access the Micro SD card slot and insert the card, proceed as follows:
1. Press the Power key to put the terminal in Suspend Mode; see Suspend Mode on paragraph 4.23.
2. Remove the battery door on the back of the unit.
3. Remove the battery and open
4. Insert the SD card with the label facing upward.
NOTE: To remove an installed SD card, tap on the edge lightly to unlock the card; the card will pop out just enough for you to grab its edge and
pull it out.
5. Tap the Power key to resume operation.
SCAN button
Volume Up/Down button