Quick Start Guide 4800dr ™ Document Reader
Note:Refer to your Barcode Manual for information about cleaning your device. For localized language versions of this document, go to www.handheld.com. Assembling the 4800dr Place arm on tray. Use the 3 screws provided to attach the arm to the underside of the tray.
Place the imager in the stand. Press the cable firmly into the wire run along the back of the arm. (You must use the USB cable that’s supplied with the 4800dr or a compatible 5 volt powered cable.
Imager Mounting Details If you are planning to mount the imager in a fixed position, the following diagram shows the mounting hole placement and details. All measurements are in inches. Connecting to the Host Turn off computer’s power before connecting the document reader, then power up the computer once the document reader is fully connected.
TTL-232 Connection 4
Interface Scan the barcode that describes the PC or interface you are using. USB Keyboard (PC) USB Keyboard (Mac) USB Japanese Keyboard (PC) USB HID Barcode Reader USB COM Port Emulation TTL-232 Interface Aligning the Document Reader Tray Proper cable placement is important for accurate alignment of the device. Place the cable in the wire channel if the imager will remain in the base most of the time.
3. Make sure the serial number on the alignment page (the top number) matches the serial number on your document reader. 4800dr s/n engine s/n 4. Press the button on the imager to display the illuminated aimer crosshairs. You will hear a single beep that indicates you are using the correct page. (If you hear 3 beeps and the aimer turns off, then you have the wrong alignment page for your document reader.) 5.
Europe, Middle East, and Africa Telephone: +31 (0) 40 7999 393 Fax: +31 (0) 40 2425 672 E-mail: eurosupport@handheld.com Asia Pacific Telephone - Hong Kong: +852-3188-3485 or 2511-3050 Telephone - China: +86 21 6361 3818 E-mail: aptechsupport@handheld.com Japan Telephone: +813 5770-6312 E-mail: aptechsupport@handheld.com Malaysia Telephone: +603-6201-7020 E-mail: aptechsupport@handheld.com Online Technical Assistance You can also access technical assistance online at www.handheld.com.
Europe, Middle East, and Africa Telephone: +31 (0) 40 2901 633 Fax: +31 (0) 40 2901 631 E-mail: euservice@handheld.com Asia Pacific Telephone: +852-2511-3050 Fax: +852-2511-3557 E-mail: apservice@handheld.com Japan Telephone: +813-5770-6312 Fax: +813-5770-6313 E-mail: apservice@handheld.com Online Product Service and Repair Assistance You can also access product service and repair assistance online at www.handheld.com. Limited Warranty Hand Held Products, Inc.
HAND HELD PRODUCTS RESPONSIBILITY AND PURCHASER’S EXCLUSIVE REMEDY UNDER THIS WARRANTY IS LIMITED TO THE REPAIR OR REPLACEMENT OF THE DEFECTIVE PRODUCT.
10
Hand Held Products, Inc. 700 Visions Drive P.O.
