Barcode Reader User Manual

8 - 2 Quick Check® 600/800 Series User’s Guide
Reflectance-Based Information
When connected to a QC3800V, the Main display indicates the Series 800
verifier model, and the bottom line displays:
Linear Imager
Once a successful scan is performed, the Main display shows, for example:
Note that the second line, where the reflectance information would normally be
displayed, shows
---, which indicates that the reflectance information is not
measured. The reflectance information is measured and displayed when a
Mouse Wand or Pen Wand is connected to the Series 800, but not when a
QC3800V is used. No reflectance-based values are displayed or printed. This
includes Rmin, Rmax, Print Contrast Signal, Symbol Contrast, Edge Contrast
Minimum, Modulation, and Defects.
ScanProfile Output
No ScanProfile Output is available in either the Printer Output modes or the
"PROF to PC" mode (as used by QCViewerII software).
Percent Decoded/Scanned Mode
No Reflectance Calibration is necessary when the QC3800V is connected.
When a Mouse Wand or Pen Wand is reconnected, however, the reflectance
calibration is necessary.
When using the QC3800V, a special Percent Decoded/Scanned Mode replaces
the Reflectometer Mode found on a Series 600 verifier. When the QC3800V is
connected, the second level (Print Results) menu changes from:
* Print Results
* Calculate "X"
* Reflectometer
* Change Settings
C39:ABCD012345678
Dim --- Fmt
Decod’ty 75% <A>
WN Ratio 2.3 OK!