Barcode Reader User Manual

5 - 8 Quick Check® 600/800 Series User’s Guide
The printer has a replaceable cartridge ribbon. Replace the paper roll when it is
empty.
♦ To turn on and off the QCP or QCHSP:
1. To turn on the printer, press the power switch into the On (center) position.
2. To turn off the printer, press the power switch into the Off (down left) position.
After you turn off the printer, wait at least three seconds to turn on the power
for the proper initialization procedure.
♦ To set up the QCP or QCHSP:
1. Place the printer on a hard, flat surface such as a table or desk top.
2. Press the power switch into the Off (down left) position.
3. Plug the power connector from the transformer into the printer.
4. Plug the transformer into a VAC wall outlet.
♦ To install or replace the QCP or QCHSP paper roll:
1. Press the printer power switch to the Off (down left) position.
2. Remove the printer cover by locating the four small grooves embossed on
each side of the printer cover and tilting the cover open by pushing down
gently on both sets of these grooves.
3. If necessary, remove the empty roll. Press and hold the power switch in the
Paper Feed (down right) position to advance the paper about one inch
beyond the paper cutter.
Lift the empty roll from the printer housing.
Do not pull paper out of the back of the printer as this will
damage the mechanism.
4. Unroll several inches of paper from a new roll and cut a straight edge on the
paper if it is jagged or wrinkled. (A straight edge helps guide the paper into
the printer.)
WARNING