User manual

Index–3
Serial Commands, 4-1
Command Conventions, 4-2
Command Format, 4-2
Configuration Commands, 4-5
Set Beeper Mode Command, 4-14
Set Codabar Command, 4-12
Set Code 128 Command, 4-14
Set Code 39 Command, 4-12
Set Communications Port Command, 4-6
Set Communications Protocol Command, 4-9
SetI2of5Command, 4-13
Set No Read Message Command, 4-11
Set Postamble Command, 4-8
Set Preamble Command, 4-7
Set Read Timeout Command, 4-10
Set Scan Rate Command, 4-14
Set Trigger Mode Command, 4-10
Set UPC A/E, EAN 8/13 Command, 4-13
Set Votes Command, 4-11
Configuration Status Query Commands, 4-15
Beeper Status, 4-15
Codabar Status, 4-15
Code 128 Status, 4-15
Code 39 Status, 4-15
Communications Port Status, 4-15
Communications Protocol Status, 4-15
Configuration Query, 4-15
Interleaved 2 of 5 Status, 4-15
No Read Message Status, 4-15
Preamble Status, 4-15
Read Timeout Status, 4-15
Scan Rate Status, 4-15
Trigger/Enable Mode Status, 4-15
UPC, EAN Status, 4-15
Votes Status, 4-15
Operational Commands, 4-3
Disable Decoding Command, 4-3
Enable Decoding Command, 4-3
Reset Command, 4-3
Save Configuration Command, 4-4
Serial Trigger 1 Command, 4-4
Serial Trigger 2 Command, 4-4
Serial Commands Summary, C-1
Configuration Commands Summary, C-1
Configuration Status Query Commands Summary, C-2
Default Configuration Settings, C-3
Operational Commands Summary, C-2
Service
Hong Kong, 5-4
Ireland, 5-3
U.K., 5-3
U.S., 5-3
Software Description, 1-2
System Hardware Description, 2-1
See also Hardware Description
System Operation, Block Diagram, 2-1
T
Timing Sequence, A-3
Troubleshooting Guide, 5-1
Diagnostic Procedure, 5-2
Troubleshooting Checklist, 5-2
Troubleshooting Hints, 5-1
W
Welch Allyn Product Service
Asia, 5-4
Europe and Great Britain, 5-3