User manual

4–4 Configuring the SCANTEAM 3700
Serial Trigger Command <1>
COMMAND
ASCII Hex Characters
Serial Trigger <1> 3C 31 3E
Sending the operational command <1> sends a serial trigger to scanner port “1.” If the
Trigger Mode for Port “1” is set to allow serial triggers, the 3700 enables the Machine
Mount CCD and attempts to read a bar code.
Trigger Mode, a configuration command, is described in section 4.4.
Serial Trigger Command <2>
COMMAND
ASCII Hex Characters
Serial Trigger <2> 3C 32 3E
Sending the operational command <2> sends a serial trigger to scanner port “2.” If the
Trigger Mode for Port “2” is set to allow serial triggers, the 3700 enables the auxilliary
wand input port. The hardware configuration to support this port is optional.
Save Configuration Command <Z>
COMMAND
ASCII Hex Characters
Save Configuration <Z> 3C 5A 3E
Sending the operational command <Z> causes the current configuration to be saved in
non–volatile memory.