User's Manual


500-24050, Rev. B 1
DRAFT
R100H Aperio
®
Reader
Installation Instructions
Package Contents
Recommended Tools
Approved Credential
(i.e., iCLASS or Prox ID card)
Level
Pencil, wax pencil
Optional Dress Cover: R100-DCA
Optional Clamping device
Product Specifications
Hub Power Requirement: 8–24 VDC, 250 mA
Wireless Frequency: 2.4 GHz, IEEE 802.15.4, using AES 128-bit encryption
Lock Battery Type: CR2, providing 35,000 Cycles
Compliance: FCC Part 15, Class B, Industry Canada
Reader Operating Temperature: –40F (–40C) to 122 F (+50C)
Credentials Supported: Type: Proximity iCLASS
Frequency: 125 kHz 13.56 MHz
Model Identifier: R100-PA2 R100-SE2
FCC Identification: VC3-KKSR100PA VC3-KKSR100SE
IC Identification: 7160A-KKSR100622PA 7160A-KKSR100622SE
System Overview
The R100 Aperio
®
Reader (R100) installs in locations where wiring may be difficult or undesired for aesthetic
reasons. The R100 connects to the access control system through the included communication hub, and the
communication hub connects to the access control system with wiegand wiring typical of a wiegand reader.
When a credential card is presented to the reader, a request for access is sent wirelessly to the communication hub,
which then communicates through wiegand wiring to the access control system where the decision is made to grant
or deny access. When access is granted the access control system unlocks the locking device seperately.
Aperio Hub
Hub Mounting
Bracket
Glue
Reader
Screws
CR2 Battery
Hex
Wrench
Securitron Magnalock Corp.
Phoenix, AZ
800.624.5625
www.securitron.com
