User's Guide

3080076.002, Rev. X01 Draft ©2013, HES, Inc. 9
11. Install the antenna/reader.
11a. Place and hold the antenna/reader to the
outside of cabinet, routing the wire through
the 1/2” offset hole.
11b. Install the top screw, which attach the
antenna/reader to the outside case.
Refer to the table below to determine the
length of the top mount screw needed, based
on the thickness of the cabinet door.
WARNING!
Make sure you avoid crimping the wires.
Crimped wires may prevent the Reader and Lock
from functioning.
.
12. Install the lock.
12a. Remove the battery cover from lock. Place the lock on the inside of the door, threading the cable
through the lock.
12b. Using two 8-32 lock mount screws (see table 2 for length), attach the lock to the antenna/reader.
Tighten the screws.
12 c. Install the two #6 self threading screws and tighten.
Reader mounting screw.
11a
11b
Table 2
Thread the cable
through the hole
in the lock.
12a
12b
12c