User's Guide

3080076.002, Rev. X01 Draft ©2013, HES, Inc. 5
4. Testing the Lock with the Access Control System
With the hub connected to power and the access control system, test the lock with a known
good credential to confirm it will open as desired when installed.
1. Remove the battery cover from
the lock body
2. Pass the wire and shaft from the
reader through the lock body.
3. Connect the wire from the reader to
the socket in the lock battery
compartment. The wire is keyed.
4. Install the batteries, ensure correct
orientation. The lock will self test
and beep once.
5. Present a credential
known to the access
control system.
6. A green LED indicates
access is granted; twist the
knob to retract the latch.
Refer to the LED reference
card for any other codes.
7. Remove the batteries, carefully
unplug the cable and separate
the lock and reader to prepare
for installation.
Testing the lock