User Guide

Technical Drawings
7.
Three-view Drawing
7⸠1
6.1
Failure of Cartridge Cylinder
1.
2.
3.
4.Check whether t he solenoid valve changes the direction normally.
5.
6.
Check whether air supply is connected well.
Check whether air pressure is too low. If so, adjust the pressure relief valve
to proper air pressure.
Check whether the magnetic switch sends out signal.
Check whether the throttle valve of cartridge cylinder is normal. If not,
adjust the air flow properly.
Check whether there is any foreign object blocked in the discharge port and tubes.
6.2
Inaccurate Filler Volume
1.
2.
3.
4.
5.
6.
Check whether the seal ring is worn (Refer to paragraph 5.1).
Check whether the magnetic switch (back) sends out signal.
Check whether the cartridge and cylinder is in right alignment when you
disassemble or mount the cartridge.
Check whether there is any material leakage on the connector of each part and
discharge nozzle.
Check whether the turning valve is blocked by any foreign object.
Check whether the discharge nozzle cartridge and its cylinder work
Check the position of turning valve core and valve body (refer to Fig. 4.1.4)7.
6.3
Failure of Inching Work
1.
2.
3.
4.
Check whether the inching socket (Fig. 3-5) is loose and the wiring is firm or not.
Check whether the inching switch works normally.
Check whether the fore and back magnetic switches work normally.
Check whether the solenoid valve exchanges the direction normally.
6
6
Troubleshooting
6.