User's Instructions

● Can I switch the audio confirmation off?
○ Yes – if you would prefer or need to use the charger without
the audio confirmation buzzer system, you are able to turn it off.
However, without the audio confirmation, your phone is not
necessarily charging just through the charging indication on
your screen which is why the audio buzzer system was initially
created. If you choose to use the device without the buzzer,
please ensure your alignment and setup is correct and accurate.
● Why do the charging speeds vary?
○ Different phones have different battery sizes and therefore take
different times to charge, with larger batteries taking longer.
Charging speeds may also slow at ≥80% in IOS models due to
Apple software requirements designed to limit battery
deterioration during wireless charging.
The UTS-1 recognises IOS charging signals and corresponds by
adapting charging speeds until your device requests more power.
please try turning OFF ‘Optimised Battery Charging’ in your ‘Settings’.
● What does flashing a LED indicator on the charger mean?
○ If your LED is flashing, please unplug and plug in the charger
again to reset. If it is still flashing, the UTS-1 might be damaged
through using an incorrect adaptor usage or incompatible plug
point. This can cause the overcurrent, over temperature or
overvoltage protection to take over. please contact
[e-mail] for more instructions.
■ To disable the buzzer.
Switch your height toggle switch to calibration mode and switch
back to your original height position and listen for the number
of audio beeps.
1 beep = disabled audio confirmation buzzer
2 beeps = enabled audio confirmation buzzer
Repeat again to disable or enable depending on preference.