® appendix C Router Table Handles ®
Appendix C - Router Table Handles Follow the safety and general instructions for using the KATIE JIG™ System except as indicated below. Attaching Router Table Handles to the KATIE JIG™ System Attach handles to ends of KATIE JIG™ System fixture using screws provided so that the guide/tuning forks will be down. Securely clamp the boards to the KATIE JIG® System using 2 clamps. Placement of these clamps should be done to best accommodate the boards.
Determine height for pattern bit. Thickness of tail board At least 1/16" of bearing must extend above base of router table. Pattern bit depth Trim stock or spacer 1/2" for guide forks Base of router table Routing Pins and Tails Grasp the router table handles on the side opposite the board that you wish to route, and slide the KATIE JIG™ System toward the bit. Carefully route the areas between each of the guide/tuning forks.
