Instructions / Assembly

11 MOC.YABNOTPMAH

.ecnatsissa rehtruf rofNOTPMAH-DH-558 tcatnoc esaelP

Maintenance

Care and Cleaning

Trouble Shooting

Turn the control knob to "OFF" position.

Turn LP cylinder to "OFF" position.

Store heater upright in an area sheltered from direct contact with inclement weather (such as rain, sleet, hail, snow, dust and debris).

If desired, cover heater to protect exterior surfaces and to help prevent build up in air passages.

During periods of extended inactivity or when transporting;

Turn the control knob to "OFF" position.

Disconnect the regulator from the LP Cylinder by turning counter-clockwise and move to a secure, well-ventilated location outdoors.

DO NOT store in a location that will exceed 125 degrees F.

Store heater upright in an area sheltered from direct contact with inclement weather (such as rain, sleet, hail, snow, dust and debris).

If desired, cover heater to protect exterior surfaces and to help prevent build up in air passages.

Keep exterior surfaces clean.

While washing your unit, be sure to keep the area around the burner dry at all times. If the gas control is exposed to water in any way, do

NOT try to use it. It must be replaced.

of combustion and ventilation air; keeping the ventilation opening(s) of the cylinder enclosure free and clear from debris.

Screw down the screws on pole, take out the burner head assembly.

Check if there are cracks or worn sections on hose. If yes, please call our customer service to replace hose.

At least once a year, the unit should be inspected for the presence of spiders, spider webs or other insects.

2. Heater does NOT reach the desired temperature.

1. Gas odor with extreme yellow tipping of ame.

3. Heater glow is excessively uneven.

4. Heater makes popping noises.

an burner holes

by using a heavy-duty pipe cleaner. Compressed air may help clear away smaller particles.

Ignition will not stay on

no click voice when igniting

Burner will not light

PROBLEM PROBABLE CAUSE SOLUTION

Pressure is low Fuel tank is near empty

Turn valve to ON

Contact customer service to get the component

Contact customer service

try manual ignition; if ignited, please contact customer

service to get the component

try manual ignition; if still do not ignited, contact customer

service to return goods

control valve not ON

Thermocouple broken

ignitor pin

valve broken