Instructions / Assembly

PLANNING INSTALLATION

Use two or more people for an easier installation.

1 Placing the Gas Cylinder

Open the door panel (J) and place the cylinder in the holder assembly. Turn the

cylinder clamp screw clockwise to secure the gas cylinder. See Fig. 9.

2 Attaching the Regulator

Attach the regulator to the cylinder and turn clockwise by hand. See Fig. 10.

use. See Fig. 11.

3 Checking for Leaks

1) Make leakage solution by mixing 1 part liquid dish soap and 3 parts water.

2) Spoon or brush several drops (or use squirt bottle) of the solution onto the

hose/regulator/cylinder connection.

3) Turn on the gas cylinder. Inspect the connections and look for bubbles.

4) If no bubbles appear, the connection is safe.

5) If bubbles appear, there is a leak. Loosen and re-tighten this connection. If there is

still a leak, please call customer service.

MOC.YABNOTPMAH 8

.ecnatsissa rehtruf rofNOTPMAH-DH-558 tcatnoc esaelP

Cylinder Installation

Fig.9

Fig.10

Fig.11

Fig.12

connections at the factory for leakage. In

transportation and handling some connections may

have loosened. Follow these steps to check the

hose/regulator/cylinder connections:

NOTE:

WARNING: After the cylinder is connected, the correct

position for the gas cylinder is the valve facing the burner

assembly as pictured.

WARNING:

Do not smoke during testing.

Do not test indoors.

A leak check must be performed whenever the gas

cylinder is replaced.

Tighten

regulator & cylinder

connection