Installation Guide

Page 19

AVERTISSEMENT:

1. Avant de commencer à installer ce luminaire ou d'enlever l'ancien luminaire,

déconnectez le courant en éteignant le disjoncteur ou en enlevant le fusible

correspondant du coffret à fusibles.

CONSULTER UN ELECTRICIEN QUALIFIE POUR TOUTE

QUESTION RELATIVE A L'ELECTRICITE.

En cas de questions non relatives à l'électricité à propos de ce luminaire,

veuillez contacter notre centre de Service à la Clientèle au 1-877-527-0313

ou visiter www.homedepot.com. Veuillez indiquer votre UGS 385-138 ou

UPC 725916000349.

Conserver votre reçu et ces Instructions comme Preuve d'Achat.

OUTILS REQUIS POUR L'ASSEMBLAGE & L'INSTALLATION

(non inclus):

3 Ampoules Lunettes de Protection Echelle Gants Dénudeur de

(75 watts maxima) Câbles Electriques

(ou équivalent LFC)

Tournevis à Tête Plate Tournevis à Croisillon Ruban Adhésif Isolant Pince pour Câbles Electriques

Page 6

PARTS INCLUDED FOR INSTALLATION (parts are not to scale):

1ea Lock Nut (#2) 2ea Wire Connectors (#7) 1ea Ground Screw (#8) 2ea Outlet Box Screws (#9)

1ea Mounting Strap (#10) 1ea Hex Nut (#11) 1ea Nipple (#12)

INSTALLATION INSTRUCTIONS:

1. Screw the Nipple (#12) a half-inch into the Mounting Strap (#10). Tighten the Hex Nut

(#11) against the Mounting Strap (#10) to secure the Nipple (#12). Attach the Mounting

Strap (#10) to the Outlet Box (#6) using the two Outlet Box Screws (#9). [Make sure the

longer end of the Nipple (#12) is facing outside when the Mounting Strap (#10) is attached

to the Outlet Box (#6).]

2. Wrap the ground wire from the Outlet Box (#6) around the Ground Screw (#8) on the

Mounting Strap (#10). Connect the white wire from the fixture to the white wire (neutral

wire) from the Outlet Box (#6). Connect the black wire from the fixture to the black wire

(live wire) from the Outlet Box (#6). Cover the two connections using the two Wire

Connectors (#7). Wrap the two wire connections with electrical tape for a more secure

connection. Position the wires back inside the Outlet Box (#6). Note: If you have electrical

questions, consult your local electrical code for approved grounding methods.

3. Place the Canopy (#1) over the Nipple (#12) all the way to the ceiling. Screw the Lock

Nut (#2) onto the Nipple (#12) until the Canopy (#1) is held firmly against the ceiling.

4. Installation is complete. Turn on the power at the circuit breaker or fuse box. Turn the light

switch on to activate the fixture.