Instructions / Assembly

8
To clean the xture, disconnect power to the xture by turning off the circuit breaker or by removing the fuse at the fuse box. Wait a few
minutes for the xture to cool down.
□ Use a dry or slightly dampened clean cloth (use clean water, never a solvent) to wipe the glass and surface of the xture.
□ Do not use any cleaners with chemicals, solvents or harsh abrasives. If necessary, use a mild soap to clean off any dirt or stains.
Problem Possible Cause Solution
The lights do not come on. Wall switch and/or circuit breaker is off. Turn on a wall switch and/or circuit breaker.
Incorrect or loose wire connections. Access the outlet box and x the
wire connections.
Light from another light source, such as
a street light or another light xture, is
shining onto the photocell.
Eliminate the light source or move the xture
to another location.
The circuit breaker is off. Ensure the circuit breaker is set in the ON
position.
Lights stay on throughout the day (or stay
on late into the day).
Fixture may be installed in a shaded area,
such as under a porch or an eave, and not
enough light is shining onto the photocell
during the daytime.
Relocate the xture to a well lit area.
Fuse blows or circuit breaker trips when
light is turned on.
Crossed out wires or power wire is
grounding out.
Access the outlet box and x the
wire connections.
Care and Cleaning
Troubleshooting