INSTRUCTIONS MANUAL 4-Light Semi-Flush Mount Fixture Menlo Park Collection HOME DEPOT SKU N2008 (UPC 887016005840 ) Brushed Nickel Finish Page 1
Thank you for purchasing this Hampton Bay Semi-Flush Mount Fixture. This product has been manufactured with the highest standards of safety and quality. FEATURES: 1. Easy to install. 2. For energy savings this fixture has been engineered to safely use a Self Ballasted Compact Fluorescent Lamp in place of an incandescent lamp. QUESTIONS, PROBLEMS, MISSING PARTS: Before returning to your local Home Depot, please call our Customer Service Team at 1-877-527-0313 or visit www.homedepot.com.
WARNING BECAUSE FAILURE TO COMPLY CAN LEAD TO INJURY: 1. Before starting installation of this fixture or removal of a previous fixture, disconnect the power by turning off the circuit breaker or by removing the fuse at the fuse box. 2. CONSULT A QUALIFIED ELECTRICIAN IF YOU HAVE ANY ELECTRICAL QUESTIONS. If you have any non-electrical questions about this fixture, please call our Customer Service Team at 1-877-527-0313 or visit www.homedepot.com. Please reference your SKU (N2008) or UPC (887016005840). 3.
PARTS INCLUDED FOR ASSEMBLY (parts are not to scale): 1 ea Shade (# 2) 1 ea Metal Pad (# 5) 1 ea Acrylic Pad (#4) 1 ea Top Frame (#8) 1 ea Hex Nuts (#3) 1 ea Bottom Frame (#9) 1 ea Main Fixture Body (#1) 4 ea Screws (# 7) 1 ea Finial (# 6) 1 ea “L” Phillips Screwdriver (# 24) ASSEMBLY INSTRUCTIONS: 1. Carefully unpack the fixture. Lay out all parts on a clean surface. 2. Attach the Top Frame (#8) to the Shade (#2), as shown. 3.
ASSEMBLY: Fig. 1 (10#) Canopy (#1) Main Fixture Body (#7) Screw Light Bulb (#3) Hex Nut (#8) Top Frame (#2) Shade (#9) Bottom Frame (#4) Acrylic Pad (#5) Metal Pad (#6) Finial Fig.
PARTS INCLUDED FOR INSTALLATION (parts are not to scale): 2 ea End Caps (#11) 1 ea Mounting Plate (#15) 2 ea Hex Nuts (#12) 2 ea Fixture Mounting Screws (#13) 2 ea Mounting Screws (#14) 3 ea Wire Connectors (#16) INSTALLATION INSTRUCTIONS: 1. Thread the Fixture Mounting Screws (#13) into the provided holes of the Mounting Plate (#15), as shown. Thread the Hex Nuts (#12) onto the Fixture Mounting Screws (#13). Do not tighten the Hex Nuts (#12) at this time. 2.
INSTALLATION: (#13) Fixture Mounting Screw (#15) Mounting Plate (#14) Mounting Screw (#12) Hex Nut (#10) Canopy (#11) End Cap Page 7
TROUBLESHOOTING: Light will not turn on. Fuse blows or circuit breaker trips when light is turned on. Possible Cause Corrective Action 1. Power is off. 1. M ake sure p ower sup p ly is on. 2. Fault y swit ch. 2. Test or rep lace swit ch. 3. Faulty wire connection 3. Check wiring. Crossed wires or power wire is grounding out. Check wire connections. PRODUCT MAINTENANCE: 1.
