Instructions / Assembly

3
5
Connecting several deck lights with hardscape adaptor
6
Connecting several deck lights without hardscape
adaptor
□ Use a Philips screwdriver to unscrew the screw connecting the foot base (1) at
the opposite end of the deck light (A) where the male plug (B) is located. Twist
off the foot base (1) from the deck light (A). Remove the plastic plug (2).
Replace the foot base (1) and rescrew it into place. Repeat for all deck lights
(A).
□ Depending on your installation requirements, refer to Steps 3 or 4 for the
installation of the individual fixtures.
□ After installation of all deck lights (A) is completed, insert the male plug (B) on
the second deck light into the electrical hole of the first deck light [which was
previously covered by the plastic plug (2)]. Repeat to connect all of your deck
lights (A) together in a daisy chain fashion. (You can connect up to 13 deck
lights (A).)
□ Insert the male plug (B) into the female plug (E).
□ Proceed to Step 8.
□ Twist off the foot base (1) from the deck light (A) at the opposite end of
the deck light (A) where the male plug (B) is located. Remove the
plastic plug (2). Replace the foot base (1). Repeat for all deck lights
(A).
□ Depending on your installation requirements, refer to Steps 2 or 3 for
the installation of the individual fixtures.
□ After installation of all deck lights (A) is completed, insert the male
plug (B) on the electrical hole of the first deck light [which was
previously covered by the plastic plug (2)]. Repeat to connect all of your
deck lights (A) together in a daisy chain fashion. (You can connect up to
13 deck lights (A).)
□ Insert the male plug (B) into the female plug (E).
□ Proceed to Step 8.