Installation Guide

Assembly and Installation (Continued)
□ This control box (H) is weatherproof and suitable for outdoor use.
□ Do not install behind shrubs. It will affect the dusk-to-dawn
photocell.
□ Photocell will not operate properly if installed too close to a
nighttime light source.
□ MOUNT AT LEAST 12 in. (30 cm) ABOVE GROUND.
□ Mount the controller with a screw (not included) on a wall within
1 ft. (30.5 cm) of the electrical outlet where the transformer will be
connected.
□ The control box (H) goes between the transformer (F) and the
lights. Plug them together and secure them with screw caps.
3
Installing the control box
4
Connecting the cable to the transformer
WARNING: To reduce the risk of FIRE OR INJURY TO PERSONS:
WARNING: Do not install within 10 ft. (3 m) of a pool, spa or fountain.
WARNING: There are no serviceable parts inside the power supply unit. DO
NOT DISASSEMBLE.
WARNING: Do not submerge the transformer.
WARNING: Do not connect two or more transformers in parallel.
WARNING: For use with 12 volt low voltage outdoor landscape lighting system
only. Not for use with submersible light or pool/spa equipment.
WARNING: Do not use with a dimmer.
CAUTION: Plug the power supply unit directly into a GFCI outlet that is marked
“wet location”.
The maximum output of this transformer is 6 watts. Do not overload
the transformer. Be sure that the total cumulative wattage of all 12 volt xtures
connected to the transformer is equal to or less than 6 watts. This garden light
system must be installed in accordance with all local codes and ordinances. If you
are experiencing problems, contact a qualied electrician.
WARNING: Do not use an extension cord.
□ Connect the wire to the transformer (F).
□ Screw the watertight connector by turning clockwise.
□ Plug the transformer (F) into the GFCI receptacle.
H
g. 1 g. 2
F
Note: Prior to installing and powering the transformer, a safety approved GFCI receptacle
(g. 1) and GFCI watertight protective cover (g. 2)– (not supplied) must be installed by
a qualied electrician. GFCI receptacle and cover must be mounted a minimum of 12 in.
(0.3 m) above ground level. The transformer must be mounted at least 1 ft. (0.3 m) above
ground level.